Transition Primer
July 12, 2024
Acrylic Exterior Paste
July 12, 2024
Hold Water
Acrylic copolymer emulsion based, silicone additives, high-quality, elastic when dry, impermeable, all to the ground, which can be easily applied by anyone, resistant to all weather conditions, developed for water proofing is a liquid plastic coating. Should be resistant to water and moisture in buildings, concrete, plaster, brick, ytong, briquette, Eternit, wood, non-gutter and with gutter roofing materials, terraces and roofs are used
PRODUCT DESCRIPTION & USE
Acrylic copolymer emulsion based, silicone additives, high-quality, elastic when dry, impermeable, all to the ground, which can be easily applied by anyone, resistant to all weather conditions, developed for water proofing is a liquid plastic coating. Should be resistant to water and moisture in buildings, concrete, plaster, brick, ytong, briquette, Eternit, wood, non-gutter and with gutter roofing materials, terraces and roofs are used
KEY BENEFITS
- Applied to the surface shows an excellent adhesion properties protect elasticity in hot and cold weather.
- With properties of can breathing in the wall provide eject out humidity.
- Chemical and UV resistance is high.
- Is impermeable water,
- Decorative,
- Can be repaired, painted over without peeling and cracking creates an elastic film layer.
AVAILABLE IN SIZES
In 3.5 kg, 10 kg, 20 kg plastic buckets
COLOUR & GLOSS RANGE
Various colour options, semi-matt
FLASH POINT
Not applicable
VOC CONTENT
Lower than EU limits
COMPOSITION (Nominal)
Pigment: Lightfast pigment
Binder: Acrylic binder
Solvent: Water
SOLIDS – SPECIFIC GRAVITY
Volume Solids 65 ± 1 %
Specific Gravity 1.3 gr/ml
SURFACE PREPARATION
The application surfaces should be cleaned from the dirt, oil, dust and all loosen structured swollen layers, the faults on the surface should be removed.
APPLICATION
Pollution, oil or paste must be removed from the surface with hot water or a cloth moistened with solvent or brush and high pressure water Southwind Hold water should be applied 2-3 times without thinning and each floor should banish in the opposite direction of a previous layer. Expect at least 24 hours between layers. Hold water application has been surfaces should be protected from rain, snow and frost in 24 hours. It is recommended that it shall be applied between +5 °C and 30 °C.
SPREADING RATE
Depending on the roughness, surface pores and repair to the structure of the region 0.750 Kg/m² – 1.2 Kg/m² varies for each floor. Certain consumption is found with experiments
REDUCTION
Do not reduce this product
DRYING TIMES (SINGLE COAT, STANDARD THICKNESS)
Touch Dry: At 20 °C, first dry 2 hours
Recoat: 6 hours
Full Dry: 24hours
This is dependent upon temperature and humidity.
CLEANING UP
Clean up with soap and water. After cleaning up be sure to flush spray equipment with solvent to prevent rusting following manufacturer’s instructions. Dispose of buckets should be in accordance with local authority guidelines.
PRECAUTIONS / WARNINGS
Keep out of reach of children. Ensure good ventilation during application and drying. If the product comes in contact with the eyes rinse immediately with plenty of water. To remove splashes from skin, use soap and water or a recognized skin cleaner. Do not take internally.
STORAGE
The product should be kept in a dry place. Lid should be closed tight when not in use. Not to be exposed to direct sunlight. Stock life is 1 year in original container. Protect from freezing.
FOLLOW US ON
Online: www.southwindpaints.com
Email: info@southwindpaints.com
Phone: +90 530 429 9233
Reviews
There are no reviews yet.