Interior Paste

PRODUCT DESCRIPTION & USE

Acrylic copolymer emulsion based, water-based, interior surface correction toothpaste. Correction of surfaces on the interior of buildings, filling cracks and gaps to ensure a smooth surface. Gypsum, satin gypsum can be used instead.

 

KEY BENEFITS

• Creates non-powder, strong and a smooth surface,
• Moisture resistant,
• Does not prevent the walls to breathe,
• Because of low absorption reduces the paint consumption,
• Application is easy,
• Filling power is very high and is brought to make the surface smooth in most 2 layers. No more dust during sanding. Does not smell due to no solvent content, not harmful to human and environmental health.

 

AVAILABLE IN SIZES

In 25 kg plastic buckets

 

COLOUR & GLOSS RANGE

White, matt

 

FLASH POINT

Not applicable since this product is non-flammable

 

VOC CONTENT

Lower than EU limits

 

COMPOSITION (Nominal)

Pigment: Lightfast pigment

Binder:    Acrylic binder

Solvent:   Water

 

SOLIDS – SPECIFIC GRAVITY

Volume Solids 86.4 ± 1 %

Specific Gravity     1.732 ± 0.01 gr/cm3

 

SURFACE PREPARATION

Be applied surface should be free from reducing adhesion such as dust, oils and dirty particles, old blistered paint layers must be cleaned. Acrylic putty, one or two layer depending on roughness of the surface, should be applied with a spatula or flexible steel trowel.

 

APPLICATION

24 hours after paste application, surface defects, traces of spatula, should be resolved by sanding bringing making the surface smooth. During application and after application in 24 hours surface and ambient temperature should be minimum +5°C, surface rainfall should not take. Do not apply in very hot weather, under direct sunlight, strong wind, fog, high relative humidity or in the expectation of rain the air. Before application extreme hot surfaces should be dampened. 

 

SPREADING RATE

0.500-1.500 kg/m2

 

REDUCTION

During the application should be diluted maximum 5% with water.

 

DRYING TIMES (SINGLE COAT, STANDARD THICKNESS)

Full Dry            At 20 °C, 24 hours

This is dependent upon temperature and humidity 

 

CLEANING UP

Clean up with soap and water. After cleaning up be sure to flush spray equipment with solvent to prevent rusting following manufacturer’s instructions. Dispose of buckets should be in accordance with local authority guidelines.

             

PRECAUTIONS / WARNINGS

Keep out of reach of children. Ensure good ventilation during application and drying. If the product comes in contact with the eyes rinse immediately with plenty of water. To remove splashes from skin, use soap and water or a recognized skin cleaner. Do not take internally.

 

STORAGE

 The product should be kept in a dry place. Lid should be closed   tight when not in use. Not to be exposed to direct sunlight. Stock life is 1 year in original container. Protect from freezing.

 

FOLLOW US ON

Online: www.southwindpaints.com

Email: info@southwindpaints.com

Phone: +90 530 429 9233